I'm working in a motherboard from PCWARE (IPX1800G2), but is the same project from Gigabyte GA-J1800N-H.

The board accept start button, hold up ATX Power, but without any video.

All voltages are OK - include 1.35 from SODIMM.
I dont have any hot component, but the COM1 controller (GD75232) has a little bit hotter than any other in the board. All voltages at COM connector are OK.

Steps I has made:

- Changed power source - no changes
- Changed memory card - no changes
- unplugged 12V CPU connector - no start
- Reset BIOS - no changes

TODO:
- Reflash BIOS
- ??

Do you have any other idea?

Thanks

replace J1800

A lot of work for a bad CPU.
It's soldered on the board. Only BGA cost is much than a newer board.

Connect post card.

Processor was burned out.

I will change to an upgradable system, with LGA 1155 to my client (I3 second generation).

Thanks to all.