You got my message?

Now you need to check the health of all mosfet's from pq711 to pq742 source-drain, and maybe change pwm u3017.
Do you have an oscilloscope?

i hae check mosgert all are ok ,no i dont have osciilograf ,but i dont have 3.3v ov vready on 2 pin u 3017

here - vr_ready, it is - pwr_good. if voltage is ok - this pin HI. if no power on CPU - is LOW.
look around pwm - smd elements is ok?

as i see all smd are ok.

check rp892, rp942. and resistance from GND

rp892 in 2.0 mega ohm also 2ohm

---

Posted after 3 minutes 40 seconds:
rp942 it is 2.7 mohm

change pwm u3017

ok ,i will do it ..Also i have some problem on one board asus p8h61-mx when turn on i have beep code no ram ..I have check slot voltage everthing is ok ?maybe you have some idea?

check socket - all pin must be ideal. change CPU and RAM. check 3.3v on pin 236 all ddr slot's.
if no result - made new post in asus motherboard.

ok thanks..I will change pwr controller and inform you..One more time thanks lot for everything..

you welcome ))

good news ,i just removed pwr controller and again solder and everthing start work ..

aleksros
intel DX79TO
Maybe you have schematic or board view ?I dont have enable on pwr controller and cant find from come from signal.I search but i colud not find board view..

no, I don't have schematic or boardview for Intel motherboard.

aleksros
hi ,i please you if you can help for some problem ..I have motherboard ga-h61m-ds2 ,I will send you schematic because no board view for this model..Ok ,problem is that on phase CPU coming instead 1.1 v is 2.7v , I folow vcore line also is 2.7 v ,I alredy have change PWM controller but same ..I never before have this problem ,very strange..Maybe you can advise me ..PS VR-on is ok 1.1 V..
Posted after 16 minutes 32 seconds:
this is pictures of motherboard and voltage ..

are you have oscilloscope? you have to see pulse voltage on DL2, DL3, DL5. not constant voltage, pulse - is ok.
look around PWM DU1. SMD elements must be ok. no scratch or damage.

no,i dont have oscilloscope ,but any way is to hi voltage?I have watch around but, nothing is damage ..,there is maybe another way ?

yes. 2.7v - it's to hi.
measure all mosfet's gate-source, drain-source. measure all smd near pwm du1 and voltage on pwm du1 pin's from 1 to 40 (page 27).

Hi ,can you help me with bios for Acer Aspire ZC-700..I download from site cap file and I try with winhex cut but new one is smaller then old one I cant find way how to cut I will atach both bios,that you see ..Thanks lot ..https://mega.nz/#!EARCRAIT!JxeA0CBD7m1S ... v4K-1lUcyY
https://mega.nz/#!UMw3SYbI!7yfP_sApJsmv ... 1uiP_iL-Is

may be that help you?
i don't guru bios for notebook
on future - create a topic in the relevant section, so you can get the answer as soon as possible.

ok ,thanks lot..I m so sory ..I will open new section..