Hello i have a gtx1060 armor v328 v6.1 with problems.
First there is no memory voltage. I changed the driver uP1537 because i had few ohms on the gate of upper mosfet( mosfet ok) .
Still no voltage but the area from picture is getting veeery hot.
Any suggestions?
Anyone has the schematic please?please please
Resistance on memory 40ohms!!! . All other voltages are ok.

Is a hot element detected by a finger?

Yes all those tranzistors seams too hot to touch

Check out hot items outside psb

I don't understand

Remove the hot transistors from the board (psb) and check them with a multimeter. I can’t write more clearly.

Ok thanks

You can also use receipt paper to see what component is hot. Put receipt paper on top of that area and hold with finger. You will see what location changes colour.

Ok the component that is going too hot is the 7002k smd from the picture. i changed it with same type but still same problem hot again. Im lost in pcb trying to understand the logic without schematic grrr.

---

Posted after 3 hours 14 minutes 48 seconds:
That 2ng37 or 2n636 from picture anyone knows what it is?

it is 2n7002, n-mosfet

check your email

3.3v after is from some power supply? I got 0 there but resistence is 470ohms

check q530, q4705, q9

Check email please
All 3 seams ok same readings on all no short

Any ideea if on gate of Q31 we need to have some voltage or 0V if 1.8v is ok? I have 0 and 1.8v is present
What value has R609? Thanks

r609 - 100k.
it's ok

Q31 was faulty with code LP. I changed it and now i have all voltages but no image. vram 1.410v! . Pcie led rest red and gpu is getting slightly hot only

code LP = DRA2144T - DRA5144T

thanks to all for great help especially to aleksros
(i'm a beginner and this is a hobby for me)
results of this trying to fix= the gpu seams dead:
all voltages are ok
all resistances seams good except gpu (<0.5ohms!!!) 0.866V ;
board is not detected at all;
pcie red led rest on;
no black screen or anything;
gpu is getting only worm not hot at touch;
pcie lines seams ok
osc 27mhz ok
1.8v on bios chip ok
no physical damage found
in windows with other good card no detection

ilie321, рlease checkmark "resolved".