hi all there is no +3VALW , +5VALW because the EC_ON is 0v , i reprogrammed kb9022 nothing change , i have replaced it and nothing change you should know the laptop is charging so all signal are ok , many laptops the EC_ON are 0v , why? and how to fix it?
note i connect 3 volt to pin EC_ON 3,5 are raised but nothing change

Does your board have UGC1 installed ?

no UGC1 at all

What about ldo's? 14 and 15 pins on pu2.
ec_on is signal FROM pu2 (on scheme)
enable signals for +3/5valw is entrip1/2, for RT8243A its from-ic signals, connected to gnd with 100k resistors (see datasheet), so if ldo's are in normal values and no shorts on +3/5valw - try to change the pu2.

and what about power key? signals on jpwr1?

all lodos are ok