U-Boot 2010.06 (Sep 02 2015 - 10:17:06)
NAND: Special Nand id table Version 1.35
Nand ID: 0x00 0x00 0x00 0x00 0x00 0x00 0x00 0x00
No NAND device found!!!
0 MiB
Check spi flash controller v300. found
Spi(cs1) ID: 0xC2 0x20 0x19 0xC2 0x20 0x19
Spi(cs1): Block:64KB Chip:32MB Name:"MX25L25635E/735E"
MMC: Card did not respond to voltage select!
No EMMC device found!!!
In: serial
Out: serial
Err: serial
USB: scanning bus for devices... 2 USB Device(s) found
usb_stor_get_info->1422,blksz:512
1 Storage Device(s) found
Interface: USB
Device 0: Vendor: VendorCo Rev: 2.00 Prod: ProductCode
Type: Removable Hard Disk
Capacity: 60000.0 MB = 58.5 GB (122880000 x 512)
Partition 1: Filesystem: FAT32 "NO NAME "
reading kt_cleartimestamp.img
...
reading 3531/kt_cleartimestamp.img
...
reading upgrade.dvr
...
reading 3531/upgrade.dvr
...
reading boot.img
...
reading 3531/boot.img
...
reading env.img
...
reading 3531/env.img
...
reading kt_mac.img
...
reading 3531/kt_mac.img
...
reading logo_upgrade.img
...
reading 3531/logo_upgrade.img
...
reading logo_boot.img
...
reading 3531/logo_boot.img
...
reading app_param.img
...
reading 3531/app_param.img
...
reading kernel.img
...
reading 3531/kernel.img
...
reading rootfs.img
...
reading 3531/rootfs.img
...
reading app.img
...
reading 3531/app.img
...
memcmp =0
UpgradeSoftware MemAddr:00000000 param addr 00080000
CheckUpgrade invalid addr(0x00000000)
32768 KiB hi_sfc at 0:0 is now current device
jpeg decoding ...
<<addr=0x82000000, size=0x20000, vobuf=0x8f000000>>
mmu_enable
<<imgwidth=800, imgheight=600, linebytes=1600>>
decode success!!!!
bootdelay=7
Press CTRL-C to abort autoboot in 0 seconds
32768 KiB hi_sfc at 0:0 is now current device
## Booting kernel from Legacy Image at 82000000 ...
Image Name: Linux-3.0.8
Image Type: ARM Linux Kernel Image (uncompressed)
Data Size: 1864592 Bytes = 1.8 MiB
Load Address: 80008000
Entry Point: 80008000
Loading Kernel Image ... OK
OK
Starting kernel ...
Uncompressing Linux... done, booting the kernel.
UART