Ремонт: Ноутбуков, Компьютеров
https://vlab.su/

E5440 (la-9832p) AC Adapter Unkown
https://vlab.su/viewtopic.php?f=41&t=122667		 Страница 1 из 1
R EZ A [ 22 янв 2022, 20:36 ]
Заголовок сообщения:  E5440 (la-9832p) AC Adapter Unkown
Hello all
i got a dell laptop with board number la-9832p_Rev1.0 for repair . when I connect the AC adapter it gives me an AC adapter unknown error on the bios menu. when I opened it PU1 was burned which I changed with a new one but I got still the same error. pr8, pr9 have correct ohms but I changed them with new ones. I changed pq2 too but I got the same error again. pl3 is checked and is correct too
any idea where could be the problem and I should check where?
Serguz05 [ 22 янв 2022, 21:39 ]
Заголовок сообщения:  Re: E5440 (intel) AC Adapter Unkown
NB_PSID ( PS_ID ) to multicontroller. (1-wire signal from AC adapter dell).
---------- Добавлено спустя 15 минут 32 секунды: ----------
R EZ A писал(а):
PU1 was burned

Might have to change the multicontroller. PS_ID what resistance .
check, replace PQ2, PQ3.
R EZ A [ 25 янв 2022, 20:41 ]
Заголовок сообщения:  Re: E5440 (la-9832p) AC Adapter Unkown
I changed PQ2 , PQ3 but still got an adapter unknown error. I even shorted pin 3-4 of pu1 and d-s pq2 but nothing happened
R EZ A [ 27 янв 2022, 19:45 ]
Заголовок сообщения:  Re: E5440 (la-9832p) AC Adapter Unkown
any idea ?
Serguz05 [ 27 янв 2022, 23:18 ]
Заголовок сообщения:  Re: E5440 (la-9832p) AC Adapter Unkown
Is the power supply original?
post measurements PQ2, PQ3, PD5, PU1, check resistors, check +5V_ALW, +3.3V_ALW,
ECE5048-LZY flashable multicontroller. possibly an error. but it has a locked BOOT area in which battery data is stored. it's not that easy .
попробуй другой оригинальный блок питания.
---------- Добавлено спустя 2 минуты 16 секунд: ----------
Serguz05 писал(а):
попробуй другой оригинальный блок питания.

sorry -
try another original power supply.
Vasyasneg [ 29 янв 2022, 21:55 ]
Заголовок сообщения:  Re: E5440 (la-9832p) AC Adapter Unkown
R EZ A писал(а):
when I opened it PU1 was burned which I changed with a new one

This new one PU1 was with firmware, or with empty content?
Serguz05 [ 30 янв 2022, 00:30 ]
Заголовок сообщения:  Re: E5440 (la-9832p) AC Adapter Unkown
Vasyasneg писал(а):
This new one PU1 was with firmware, or with empty content?

with what firmware ?
PU1 TS5A63157
https://www.ti.com/lit/ds/symlink/ts5a6 ... le.ru%252F
Vasyasneg [ 30 янв 2022, 11:18 ]
Заголовок сообщения:  Re: E5440 (la-9832p) AC Adapter Unkown
Sorry, I thought the speech was about the Dallas chip.
Vesko356 [ 31 янв 2022, 19:01 ]
Заголовок сообщения:  Re: E5440 (la-9832p) AC Adapter Unkown
Are you sure you've soldered PU1 correctly (I mean not upside down). What is the voltage on pin 3 and pin 4 of PU1 (and resistance to ground in NB_PSID and PS_ID lines in turned off state)? You can try to unsolder PU1 and then short pin 3 to pin 4 to see if it's working this way. Did you check PD5 (if it's present on the board)?
Страница 1 из 1 Часовой пояс: UTC + 4 часа
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/