Hello friends,
I have RX 470 4G mining card which is not working. After removing the mosfets there is still short between drain and source pads of the PCB.
I think that the problem could be a bad cap, but without schematic it is not easy, I just dont know where to start from. I am uploading a photo of the PCB with removed mosfets. Any idea will be helpfull!! Thanks for the support !!

Можно точный замер сопротивления?
---------- Добавлено спустя 5 минут 9 секунд: ----------
Эту тему видели возможно пригодится viewtopic.php?f=48&t=83905

I measure 1,2ohms between Source and Drain with probe which is 0,7ohms.
Я измеряю 1,2 Ом между истоком и стоком с помощью щупа, который составляет 0,7 Ом.
thanks

на них какое сопротивление ???? я отметил

Between GND and Source 0,8ohms. Between GND and Drain 1,4ohms.
Между GND и источником 0,8 Ом. Между GND и стоком 1,4 Ом

Я не понял Вас, на этих катушках какое сопротивление ???

Attaching some schematics, hopefully they can help.

Otherwise, perhaps building a short tracer (ie. "the $1 short finder" by Learn Electronics Repair on YouTube), and finding some quiet time might be your only answer. With good luck and educated guesses, hopefully not too long with this route either.

Try to inject voltage

0.7 ohm is problem, need check some resitance