Hi,

Could anyone have a working dump?

Regards.

Official site + your DMI.

Thank you. I have put your code, now when i press the power button the fan moves a bit. I think the Embedded Controller code is the issue. Could you have one I can try ?

I haven't EC bios.
Marking EC or/and EC flash?

I have ordered another board, I will provide a working dump when it arrives.

Hello,

The working board did arrive and tested fine. The only difference is the old board supported 2nd generation processors the new one supports 3rd generation. The EC code was in Pm25LD512 which my programmer cannot read its chip ID, So i did a few dumps from different chip companies with the some size 25*512. Hope it helps.

Regards.