I've discovered some interesting things to share with you on this model made by Satan himself
I faced this board LA-H811P with no power at all, found a bad type-c connector and a shorted TPS65987DD pd controller, after replacing the connector and removing the dead pd chip I was surprised that this board can give dell's logo with no backlight while vcore = 0v
Closer inspection reveals tons of dead AOZ1334DI chips so I replaced them all... a dead ALC3281 codec and a bad UC4 (and gate) too...
after replacing them all the board started to work but freezing on dell's logo, I also noticed that the battery isn't charging, first thing I did is flashing the bios but nothing changed...
I've tested tons of bioses with no luck then I built it from the official update but it still freezing on the logo...
all that was done with the board working on a one pd chip, I soldered new second chip and the charging started working but it still freezing...
I've found info somewhere that this board will work only on it's original bios so I put back the original backup but I'm still out of luck..
all that until I turned it on with the battery connected and the devil initialized and started working
for the sake of experiment I've tested all the bioses I found and the one I made from the update but nothing worked, it freeze on all of them...
So I confirm that:
- this devil will not charge with only one pd controller
- this devil will not initialize without a working battery
- this devil will initialize only on the original bios OR if you're lucky enough to find a pure manufacturer unlocked bios (and I was out of luck with this)