Hello..
This laptop came with a bad ec chip, I replaced it from a donor board and flashed both main and ec bios and it started.
tried original main & ec dumps and it started on original bios, fully tested and given to the owner..
in 24 hours it came back with 1 caps-lock blink code (CPU failure

), I've read the bios and ec contents and found differences from the original backup in both chips, tried to flash it with official bios using usb recovery method without success...
unsoldered both chips and flashed them again with the original backup and it started, thought that a failed online bios update caused the problem so I went to setup to disable online update and found this option (update system and supported device firmware using local media) clicked on it to check it out and it started flashing (ssd was on the board) and when finished it turned off, it didn't restart....
I turned it on and it gave 1 caps-lock blink code again, checked the voltages and found that vccgt has 0.66v
if vccgt has high voltage during initialization that's a sign of a dead igpu, am I correct ?!
it has i5-8365u (SRF9Z) with 3.9 ohms vcore & 5.6 ohms vccgt...
replaced vccgt power & flashed with official bios again to no avail... tried to reflow the whole cpu but no success...
how the hell the igpu went dead on me, or is there 1% chance the problem could be somewhere else ?
I need an answer from the masters please...