получил доступ в консоль , TFTP заработал
CFE> HELO
CPUI
L1CI
4.1203-1.0.38-215.171
DRAM
----
PHYS
PHYE
DDR1
333H
SIZ3
SIZ2
SIZ1
RACE
PASS
----
ZBSS
CODE
DATA
L12F
MAIN
Base: 4.12_03
CFE version 1.0.38-215.171 for BCM96318 (32bit,SP,BE)
Build Date: Sat Sep 12 15:32:44 CST 2015 (
root@localhost.localdomain)
Copyright (C) 2000-2013 Broadcom Corporation.
Chip ID: BCM6318B0, MIPS: 333MHz, DDR: 333MHz, Bus: 167MHz
Main Thread: TP0
Total Memory: 16777216 bytes (16MB)
Boot Address: 0xb8000000
HS Serial flash device: name ID_W25X32, id 0xef16 size 4096KB
Total Flash size: 4096K with 1024 sectors
Flash not used for Auxillary File System
Light all CPU's LEDs for LED Test.
Board IP address : 192.168.1.1:ffffff00
Host IP address : 192.168.1.100
Gateway IP address :
Run from flash/host/tftp (f/h/c) : f
Default host run file name : ecos.lz
Default host flash file name : bcm963xx_ecos_kernel
Boot delay (0-9 seconds) : 1
Default host ramdisk file name :
Default ramdisk store address :
Board Id (0-8) : 96318REF_P300
Number of MAC Addresses (1-32) : 24
Base MAC Address : **:**:**:**:**:**
PSI Size (1-64) KBytes : 24
Enable Backup PSI [0|1] : 0
System Log Size (0-256) KBytes : 0
Auxillary File System Size Percent: 0
Main Thread Number [0|1] : 0
Device Pin : "********"
*** Press any key to stop auto run (1 seconds) ***
Auto run second count down: 0
Booting from only image (0xb8010000) ...
Linux file system CRC error. Corrupted image?
Code Address: 0x80001000, Entry Address: 0x8000113c
Linux kernel CRC error. Corrupted image?
web info: Waiting for connection on socket 0.
CFE>
Port 0 link UP
CFE> w firmware.bin
Loading 192.168.1.100:firmware.bin ...
Finished loading 8388608 bytes
Image size too big
Finished flashing image.
*** command status = -1
CFE> f firmware.bin
Loading 192.168.1.100:firmware.bin ...
Finished loading 8388608 bytes
Firmware tag version [0] is not compatible with the current Tag version [6].
*** command status = -1
Такая же реакция на прошивки с оффсайта, даже обрезал по 0x1FF
Куда дальше копать?
